Weld Cap Profile
Home Up Weld Cap Profile Weld Cap Profile

Check out the Welded Metal Sculptures from Eclectic Metals. Click here

 

Weld Cap Profile for Stringer Beads

This

Not This

I try to tie the toe of each bead to a point near the top of the previous bead. The same concept helps with fill passes to prevent valleys between beads that are sometimes hard to clean slag from.

Here is an example of a weld cap on a 2-3/4" OD x .625" Wall tube coupon . The weld was made in  the 6G position using 1/8" E7018. You can click on the picture to see the full size picture.

weldcap.JPG (153297 bytes)

 

Hit Counter Since 10/08